Gigabyte G593-SD1-AAX1 - Installing the Memory

System Hardware Installation
- 32 -
3-5-2 Installing the Memory
Before installing a memory module, make sure to turn off the computer and unplug the power
cord from the power outlet to prevent damage to the memory module.
Be sure to install DDR5 DIMMs on this motherboard.
Make sure your DIMM slots have a single latch or a double latch.
1
2
2
Follow these instructions to install a DIMM module with Single Latch :
1. Open the plastic latch of the memory slot, then place the memory module as pre-inserted vertically
position.
Movable end
Fixed end
2. Hold it with both hands, insert the memory module into the movable end rst, and then insert the
memory module into the xed end.
2
1
Movable end
Fixed end
3. Then use both hands to insert the memory module vertically into the DIMM slot and push it down.
Close the plastic latch at the edge of the DIMM slots to lock the memory module.
Movable end
Fixed end
4. Reverse the installation steps when you want to remove the memory module.
Follow these instructions to install a DIMM module with Double Latch:
1. Insert the DIMM memory module vertically into the DIMM slot and push it down.
2. Close the plastic clip at both edges of the DIMM slots to lock the DIMM module.
3. Reverse the installation steps when you want to remove the DIMM module.