Gigabyte G593-SD2-AAX1 - Page 90

- 90 -
BIOS Setup
(Note) This item is congurable when Power Performance Tuning is set to BIOS Controls EPB.
Parameter
Description
CPU C State Control
Press [Enter] to congure advanced items.

Enable Monitor MWAIT
– Allows Monitor and MWAIT instructions.
– Options available: Disable, Enable, Auto. Default setting is Auto.

CPU C6 Report
– Enable/Disable CPU C6(ACPI C3) report to OS.
– Options available: Disable, Enable, Auto. Default setting is Auto.

Enhanced Halt State (C1E)
– Core C1E auto promotion control. Takes effect after reboot.
– Options available: Enable, Disable. Default setting is Enable.
Package C State Control
Press [Enter] to congure advanced items.

Package C State
– Congures the state for the C-State package limit.
– Options available: C0/C1 state, C2 state, C6(non Retention) state,
C6(Retention) state, No Limit, Auto. Default setting is Auto.
CPU - Advanced PM Tuning
Press [Enter] to congure advanced items.

Energy Perf BIAS
– Press [Enter] to congure advanced items.
»
Power Performance Tuning
• Options available: OS Controls EPB, BIOS Controls EPB,
PECI Controls EPB. Default setting is OS Controls EPB.
»
Energy_PERF_BIAS_CFG mode
(Note)
• Options available: Performance, Balanced Performance,
Balanced Power, Power. Default setting is Balanced
Performance.
SOCKET RAPL Cong
Press [Enter] to congure advanced items.

PL1 Power Limit
– PL1 Power Limit in Watts. The value may vary from 0 to Fused
Value. If the value is 0, the fused value will be programmed.
– Default setting is 0.

PL1 Time Window
– PL1 value in seconds. The value may vary from 0 to 448.
– Default setting is 1.

PL2 Power Limit
– PL2 Power Limit in Watts. The value may vary from 0 to Fused
Value. If the value is 0, BIOS programs 120% * TDP.
– Default setting is 0.

PL2 Time Window
– PL1 value in seconds. The value may vary from 0 to 0.438.
– Default setting is 0.012.