19
Hardware Installation Process
L) Front Audio Connector
D) Floppy / IDE1 / IDE2
1
Floppy
1
IDE2
1
IDE1
G) IR
Be careful with the polarity of the IR connector
while you connect the IR. Please contact you
nearest dealer for optional IR device.
If you want to use "Front Audio" connector,
you must move 11-12,13-14 Jumper.
In order to utilize the front audio header, your
chassis must have front audio connector. Also
please make sure the pin assigment on the cable
is the same as the pin assigment on the MB
header. To find out if the chassis you are buying
support front audio connector, please contact
your dealer.
IRRX
NC
IRTX
GND
VCC
1
Incase Speaker (L)
GND
GND
GND
Rear Audio(R)
Rear Audio(L)
Incase Speaker (R)
GND
+12V
MIC
GND
GND
Front Audio(R)
Front Audio(L)
1
16
2
15
To Next Page
Loading...
