IDE RAID Drives Configuration (GigaRAID)- 13 -
RAID Card Configuration:
Press 5 in Main Menu to enter the RAID Card Configuration menu (Figure 15).
The RAID Card Configuration section: When Auto-Rebuild is enabled, the GigaRAID ATA RAID Controller
can rebuild your mirrored array automatically. If a failed mirrored drive is replaced without
shutting down your PC, the GigaRAID ATA RAID Controller can detect the hot-swap action and start
rebuilding automatically. When Auto-Rebuild is disabled, you need to rebuild your mirrored array
manually from Rebuild RAID Menu (please refer to page 11).
The RAID Card Resource section: This section displays PCI slot interrupt and I/O port address used by
the GigaRAID ATA RAID Controller.
The Driver Status section: This section displays the status of each hard drive.
Figure 15
To Next Page
Loading...
