IDE RAID Drives Configuration (GigaRAID) - 16 -
Ác
Åé
¤¤
¤å
Figure 20
Figure 21
(5) Installing IDE RAID controller driver during OS installation
Now that you have prepared a floppy disk with the IDE RAID controller driver and adjusted BIOS settings,
you are ready to install Windows 2000/XP onto your IDE hard drive with the driver. The following is an
example of Windows XP installation.
Step 1: Restart your system to boot from the Windows 2000/XP Setup disk and press F6 as soon as
you see the "Press F6 if you need to install a 3rd party SCSI or RAID driver" message (Figure 20). After
pressing F6, there will be a few moments of some files being loaded before you see the next screen.
Step 2:
When a screen similar to that below appears (Figure 21), insert the floppy disk containing the IDE RAID
driver and press S.
To Next Page
Loading...
