IDE RAID Drives Configuration (GigaRAID)- 17 -
Figure 22
Figure 23
Step 3:
If Setup correctly recognizes the driver in the floppy disk, a controller menu will appear. If you want to
install Windows XP, use the UP or DOWN ARROW key to select ITE IT8212 ATA RAID Controller
(Windows 2000/XP)* (Figure 22) and press ENTER. Then it will begin to load the driver from the floppy
disk.
If a message appears saying one or some file(s) cannot be found, please check the floppy disk
or copy the correct GigaRAID controller driver again from the motherboard driver CD.
Step 4:
When the screen as shown below appears, press ENTER to continue the driver installation from the floppy
disk. The driver installation will be finished in about one minute.
"*" Select the driver according to which of the following operating systems you want to install:
Windows XP, Windows 2000, or Windows NT.
To Next Page
Loading...
