Gigabyte GA-970A-D3P - Drivers Installation; Installing Chipset Drivers

- 61 -
Drivers Installation
4-1 Installing Chipset Drivers
Chapter 4 Drivers Installation
•
Beforeinstallingthedrivers,rstinstalltheoperatingsystem.
•
After installing the operating system, insert the motherboard driver disk into your optical drive.
The driver Autorun screen is automatically displayed which looks like that shown in the screen
shotbelow. (Ifthe driverAutorunscreendoes notappear automatically, goto MyComputer,
double-click the optical drive and execute the Run.exeprogram.)
Afterinsertingthedriverdisk,"XpressInstall"willautomaticallyscanyoursystemandthenlistallthedrivers
that are recommended to install. You can click the Install Allbuttonand"XpressInstall"willinstallalltherec-
ommended drivers. Or click Install Single Items to manually select the drivers you wish to install.
•
Pleaseignorethepopupdialogbox(es)(e.g.theFound New Hardware Wizard)displayed
when"XpressInstall"isinstallingthedrivers.Failuretodosomayaffectthedriverinstallation.
•
Some device drivers will restart your system automatically during the driver installation. After the
systemrestart,"XpressInstall"willcontinuetoinstallotherdrivers.
•
After"XpressInstall"installsallofthedrivers,adialogboxwillappearaskingwhethertoinstall
new GIGABYTE utilities. Click Yes to automatically install the utilities. Or click No if you want to
manually select the utilities to install on the Application Software page later.
•
ForUSB2.0driversupportundertheWindowsXPoperatingsystem,pleaseinstalltheWindows
XPServicePack 1 orlater.After installing theSP1 (or later),if a questionmark still exists in
Universal Serial Bus Controller in Device Manager,pleaseremovethe question mark (by
right-clicking your mouse and select Uninstall)andrestart thesystem. (Thesystem will then
autodetectandinstalltheUSB2.0driver.)