Gigabyte GA-F2A75-D3H - Chapter 3 Drivers Installation; Installing Chipset Drivers

- 55 -
Drivers Installation
3-1 Installing Chipset Drivers
Chapter 3 Drivers Installation
• Beforeinstallingthedrivers,rstinstalltheoperatingsystem.
• After installing the operating system, insert the motherboard driver disk into your optical drive.
The driver Autorun screen is automatically displayed which looks like that shown in the screen
shotbelow. (If the driverAutorunscreendoesnotappearautomatically,gotoMyComputer,
double-click the optical drive and execute the Run.exeprogram.)
Afterinsertingthedriverdisk,"XpressInstall"willautomaticallyscanyoursystemandthenlistallthedrivers
that are recommended to install. You can click the Install All button and"XpressInstall"willinstallallthe
recommended drivers. Or click Install Single Items to manually select the drivers you wish to install.
• Pleaseignorethepopupdialogbox(es)(e.g.theFound New Hardware Wizard)displayed
when"XpressInstall"isinstallingthedrivers.Failuretodosomayaffectthedriverinstallation.
• Some device drivers will restart your system automatically during the driver installation. After the
systemrestart,"XpressInstall"willcontinuetoinstallotherdrivers.
• After"XpressInstall"installsallofthedrivers,adialogboxwillappearaskingwhethertoinstall
new GIGABYTE utilities. Click Yes to automatically install the utilities. Or click No if you want to
manually select the utilities to install on the Application Software page later.
• ForUSB2.0driversupportundertheWindowsXPoperatingsystem,pleaseinstalltheWindows
XPServicePack1or later.Afterinstallingthe SP1 (or later),ifa question mark stillexistsin
Universal Serial Bus Controller in Device Manager,pleaseremovethe question mark(by
right-clicking your mouse and select Uninstall)and restartthesystem.(Thesystemwill then
autodetectandinstalltheUSB2.0driver.)