Gigabyte GA-F2A75-D3H - Configuring SATA Controller Mode in BIOS Setup; SATA Controller Mode Settings (IDE, RAID, AHCI)

Appendix
- 70 -
The BIOS Setup menus described in this section may differ from the exact settings for your mother-
board. The actual BIOS Setup menu options you will see shall depend on the motherboard you have
and the BIOS version.
Step 2:
Save changes and exit BIOS Setup.
Figure 1
B.ConguringSATAcontrollermodeinBIOSSetup
MakesuretoconguretheSATAcontrollermodecorrectlyinsystemBIOSSetup.
Step 1:
Turnonyourcomputerandpress<Delete>toenterBIOSSetupduringthePOST(Power-OnSelf-Test).Make
sure OnChip SATA Controller is enabled. To enable RAID for the SATA3 0/1/2/3 connectors, set OnChip
SATA Type to RAID. To enable RAID for the SATA3 4/5 connector, set OnChip SATA Type to RAID and set
OnChip SATA Port4 Type to As SATA Type(Figure1).