Gigabyte GA-G41M-Combo - Page 35

- 35 - BIOS Setup
System Memory Multiplier (SPD)
Allows you to set the system memory multiplier. Options are dependent on CPU FSB and the (G)MCH
Frequency Latch settings. Auto sets memory multiplier according to memory SPD data. (Default: Auto)
Memory Frequency (Mhz)
The rst memory frequency value is the normal operating frequency of the memory being used; the
second is the memory frequency that is automatically adjusted according to the CPU Host Frequency
(Mhz) and System Memory Multiplier settings.
DRAM Timing Selectable (SPD)
Manual allows all DRAM timing control items below to be congurable. Options are: Auto (default),
Manual.
>>>>> Standard Timing Control
CAS Latency Time
Options are: Auto (default), 4~11.
tRCD
Options are: Auto (default), 1~15.
tRP
Options are: Auto (default), 1~15.
tRAS
Options are: Auto (default), 1~63.
>>>>> Advanced Timing Control
Advanced Timing Control
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Advanced Timing Control
higf
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

x tRRD Auto
x tWTR Auto
x tWR Auto
x tRFC Auto
x tRTP Auto
x Command Rate (CMD) Auto
>>>>> Channel A

Channel A Timing Settings [Press Enter]

Channel A Driving Settings [Press Enter]
>>>>> Channel B

Channel B Timing Settings [Press Enter]

Channel B Driving Settings [Press Enter]
tRRD
Options are: Auto (default), 1~15.
tWTR
Options are: Auto (default), 1~31.