Gigabyte GA-IMB1900TN - Advanced

2-3 Advanced
& OnBoard LAN Controller (LAN1)
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
& OnBoard LAN Controller#2 (LAN2)
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
& Resume by Alarm
Determines whether to power on the system at a desired time. (Default: Disabled)
If enabled, set the date and time as following:
Wakeupday:Turnonthesystemataspecictimeoneachdayoronaspecicdayinamonth.
Wake up hour/minute/second: Set the time at which the system will be powered on automatically.
Note: When using this function, avoid inadequate shutdown from the operating system or removal of the
AC power, or the settings may not be effective.
` IT8786SuperIOConguration
 ThissectionprovidesinformationonthesuperI/Ochipandallowsyoutoconguretheserialportand
parallel port.
` Hardware Monitor
& System Fan mode
Auto Lets the BIOS automatically detect the type of fan installed and sets the optimal control
mode. (Default)
Pwm PWM mode is recommended for a 4-pin fan.
Voltage Voltage mode is recommended for a 3-pin fan.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Main
OnBoard LAN Controller [Enabled]
OnBoard LAN Controller#2 [Enabled]
Resume by Alarm [Disabled]
Wake up day 0
Wake up hour 0
Wake up minute 0
Wake up second 0
` IT8786SuperIOConguration
` Hardware Monitor
` Intel(R) Smart Connect Technology
` SIO Misc Functions
` CPUConguration
` PPMConguration
` ThermalConguration
` IDEConguration
` NetworkStackConguration
` CSMConguration
` NVMeConguration
` USBConguration
` Intel(R) I211 Gigabit Network Connection - 00:1F:D0:00:...
` Intel(R) I211 Gigabit Network Connection - 00:1F:D0:00:...
gf: Select Screen
hi: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Boot Save & ExitSecurityChipsetAdvanced
- 24 -