Gigabyte GA-VM900M - RAID BIOS Configuration Utility

GA-VM900M Motherboard - 58 -
English
(3) Configuring RAID set in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step and proceed to OS installation
if you do not want to create RAID.
Step 1:
After the POST memory test begins and before the operating system boot begins, the following
information will appear on screen (Figure 3). Press <Ctrl>+<Z> to enter the VIA VT8237S V-RAID utility.
Figure 3
Step 2:
In the RAID BIOS utility screen (Figure 4), you can use the UP or DOWN ARROW key to highlight
through choices. Highlight an item that you want to execute and press ENTER.
Figure 4
VIA Technologies, Inc. VIA VT8237S V-RAID CDROM BOOT BIOS V1.20
Copyright (C) VIA Technologies, Inc. All Right reserved.
237SR120.ROM-FOR RAID
Scan Devices, Please wait...
No Raid
Channel0 Master ST3120026AS --SATA mode
Channel1 Master ST3120026AS --SATA mode
Press Ctrl+Z into User Window!
XX
XX
X Create Array
XX
XX
X Delete Array
XX
XX
X Select/Clear Boot Array
XX
XX
X Serial Number View
Dev. Posi. Drive Name Array Name Mode Size(GB) Status
Channel0 Master ST3120026AS SATA 111.79 Hdd
Channel1 Master ST3120026AS SATA 111.79 Hdd
Create a RAID array with
the hard disks attached to
VIA RAID controller
F1 : View Array/disk Status
KK
KK
K ,
LL
LL
L : Move to next item
Enter : Confirm the selection
ESC : Exit
VIA VT8237S V-RAID Utility V1.20