Gigabyte GA-X150-PLUS WS - Page 15

8) BAT (Battery)
 Thebatteryprovidespowertokeepthevalues(suchasBIOScongurations,date,andtimeinformation)
intheCMOSwhenthecomputeristurnedoff.Replacethebatterywhenthebatteryvoltagedropstoalow
level, or the CMOS values may not be accurate or may be lost.
You may clear the CMOS values by removing the battery:
1. Turn off your computer and unplug the power cord.
2. Gently remove the battery from the battery holder and wait for one minute. (Or
use a metal object like a screwdriver to touch the positive and negative terminals
ofthebatteryholder,makingthemshortfor5seconds.)
3. Replacethebattery.
4. Plug in the power cord and restart your computer.
• Always turn off your computer and unplug the power cord before replacing the battery.
• Replacethebatterywithanequivalentone.Dangerofexplosionifthebatteryisreplacedwith
an incorrect model.
• Contact the place of purchase or local dealer if you are not able to replace the battery by yourself
or uncertain about the battery model.
• Wheninstallingthebattery,notetheorientationofthepositiveside(+)andthenegativeside(-)
ofthebattery(thepositivesideshouldfaceup).
• Used batteries must be handled in accordance with local environmental regulations.
The PCI slots share bandwidth with the M2F_32G and SATA Express connectors. Whether the SATA
ExpressconnectorcanbeusedisdependentonthetypeofM.2SSDbeinginstalled.Pleasereferto
the table below:
SATA Express SATA3_0 SATA3_1 SATA3_2 SATA3_3 SATA3_4 SATA3_5
M.2SATASSDInstalled
a a a a a a
r
(Note2)
M.2PCIex4SSD
Installed
(Note1)
r
a a a a a a
M.2PCIex2SSDInstalled
r
a a a a a a
NoM.2SSDInstalled
a a a a a a a
a: Available,r: Not Available
(Note1) The M.2 PCIex4SSDwillrunatx2speedifa PCI slot is populated.
(Note2) TheSATA3_5connectorwillbecomeunavailableifanM.2SATASSDisinstalled.
Connector
Type of
SSDInstalled
- 15 -