Gigabyte GA-X79-UD5 - Page 92

Appendix - 92 -
Figure 3
B. Installing Windows XP (For the Marvell 88SE9172)
(Note)
-

the driver, the hard drive(s) may not be recognized during the Windows setup process. First, copy the driver

Method A:
    • \BootDrv\Marvell\RAID\Floppy32  
Floppy64 folder.
 •
AHCI\Floppy32 or AHCI\Floppy64 folder.
Method B:
Steps:
Use an alternative system and insert the motherboard driver disk.1:
From your optical drive folder, double click the 2: Menu.exeBootDrv folder. A Command Prompt
window will open similar to that in Figure 3.
3:
A). Select the controller driver by pressing the corresponding letter from the menu and press <Enter>. For
example, from the menu in Figure 3, select 7) Marvell RAID driver. (For AHCI drive(s), select Marvell
AHCI driver.)
-
ished.
(Note) The X79 SATA RAID/AHCI driver does not support Windows XP 32-bit. To install Windows XP 64-
bit, search for the installation instructions on the Support & Downloads\FAQ page on our website.