- 41 -
Enables
or
disables
IPv4
PXE
Support.
This
item
is
configurable
only
when
Network Stack is enabled.
Ipv6 PXE Support
Enables
or
disables
IPv6
PXE
Support.
This
item
is
configurable
only
when
Network Stack is enabled.
Administrator Password
Allows you to configure an administrator
password. Press <Enter> on this item, type
the password, and then press <Enter>. You
will be requested to confirm the password.
Type the password again and press <Enter>. You
must enter the administrator password (or user
password) at system startup and when entering
BIOS Setup. Differing from the user password,
the administrator password allows you to make
changes to all BIOS settings.
User Password
Allows you to configure a user password.
Press <Enter> on this item, type the
password, and then press <Enter>. You will
be requested to confirm the password. Type
the password again and press <Enter>. You must
enter the administrator password (or user
password) at system startup and when entering
BIOS Setup. However, the user password only allows you to make changes
to certain BIOS settings but not all.