- 52 -
with
an
M.2
SATA
SSD
or
a
SATA
hard
drive.
(Note 2) Refer to Chapter 1, "Internal Connectors," "M.2
Socket 3 Connector," for the configuration
tables of SATA hard drives and M.2 SSDs.
4. Under Select Disks item, select the hard drives to
be included in the RAID array. Press the
<Space> key on the hard drives to be
selected (selected hard drives are marked with "X").
Then set the stripe block size. The stripe block
size can be set from 4 KB to 128 KB. Once you have selected the stripe block size, set
the volume capacity.
5. After setting the capacity, move to Create Volume and press <Enter>
to begin.
6. After completing, you'll be brought back to the Intel(R) Rapid Storage Technology
screen. Under RAID Volumes you can see the new
RAID volume. To see more detailed information,
press <Enter> on the volume to check for
information on RAID level, stripe block size,
array name, and array capacity, etc.
C-2. Configuring Legacy RAID ROM
Enter the Intel
®
legacy RAID BIOS setup utility to
configure a RAID array. Skip this step and
proceed with the installation of Windows
operating system for a non-RAID configuration.
Steps:
1. After the POST memory test begins and before the operating system boot begins, look
for a message which says "Press <Ctrl-I> to enter Configuration
Utility". Press <Ctrl> + <I> to enter the
RAID Configuration Utility. 2. After you press <Ctrl>
+ <I>, the MAIN MENU screen will appear.
If you want to create a RAID array,
select Create RAID Volume in MAIN MENU and press
<Enter>.
3. After entering the CREATE VOLUME MENU screen, enter a volume
name with 1~16 letters (letters cannot be special
characters) under the Name item and press
<Enter>. Then, select a RAID level. RAID levels
supported include RAID 0, RAID 1, Recovery,
RAID 10, and RAID 5 (the selections
To Next Page
Loading...
