- 13 - Hardware Installation
Storage Per node:
3 x 3.5" SATA/SAS hot-swappable SSD bays
1 x SATA DOM
Total:
12 x 3.5" SATA/SAS hot-swappable SSD bays
4 x SATA DOM
Expansion Slots Per node:
2 x Low prole half-length slots with PCIe x16 (Gen4 x16 bus)
1 x OCP 2.0 mezzanine slot with PCIe Gen3 x8 bandwidth (Type1, P1, P2 with
NCSI supported)
Total:
8 x Low prole half-length slots with PCIe x16 (Gen4 x16 bus)
4 x OCP 2.0 mezzanine slots with PCIe Gen3 x8 bandwidth (Type1, P1, P2 with
NCSI supported)
Internal I/O Per Node:
1 x USB 3.0 header
1 x SATA DOM
1 x TPM header
1 x OCP 2.0 mezzanine slots
1 x Front panel header
1 x Back plane board header
1 x IPMB connector
1 x Clear CMOS jumper
1 x BIOS recovery jumper
To Next Page
Loading...
