System Hardware Installation - 38 -
3-9 Installing the OCP Card
Follow these instructions to install the OCP card:
1. Install the OCP card bracket.
2. Secure the OCP card bracket with a screw.
3. Align the OCP card to the connector on the system board and push in the direction of the arrow
until the OCP card sits rmly in the system.
4. Secure the OCP card with three screws.
• Before installing the OCP card the left PCI-E riser assembly must be rst removed, see
the 「Installing the PCI Expansion Card「 section for instructions on removing the PCI-E
riser assembly.
• Use the following type of OCP 2.0 NIC: Type1, P1, P2, P3, P4
4
3
1
2
To Next Page
Loading...
