1
2
3
3-2 Installing a 3.5" Drive
Refer to the following steps to install a 3.5" drive:
1. Remove the two screws from the side panel. Then pull out the side panel.
2. Press the tabs of the 3.5" drive bracket on both sides to pull the bracket out of the desktop computer.
3. Secure your 3.5" drive into the bracket by inserting the four pins on the sides of the bracket into the mounting
holes on the sides of the drive.
4. Replace the bracket with the installed 3.5" drive in the desktop computer. Replace the side panel and secure
it with the screws you previously removed.
- 20 -
To Next Page
Loading...
