- 35 - BIOS Setup
2-2-3 SATAConguration
SATAConguration
SATA Port 0/SATA Port 1/mSATA
The category identies Serial ATA and mSATA types of hard disk that are installed in the computer.
System will automatically detect HDD type.
Note that the specications of your drive must match with the drive table. The hard disk will not work
properly if you enter improper information for this category.
Hard drive information should be labeled on the outside device casing. Enter the appropriate option
based on this information.
Type
Auto: Set parameters automatically. (Default setting)
CD-ROM: Use for ATAPI CD-ROM drives or double click [Auto] to set all HDD parameters
automatically.
ARMD: Use ARMD drive is installed here.
LBA/Large Mode
Congure the device type in the specic IDE channel support LBA Mode.
Option available: Auto/Disabled. Default setting is Auto.
Block (Multi-Sector Transfer)
Congure the information of Multi-Sector Transfer Mode.
Auto: The data transfer from and to the device occurs multiple sectors at a time if the device
supports it.
Disabled: The data transfer from and to the device occurs one sector at a time.
Option available: Auto/Disabled. Default setting is Auto.
To Next Page
Loading...
Need help?
General
