Gigabyte MU92-TU1 - Pch Configuration

- 65 - BIOS Setup
2-3-7 PCH Conguration
Parameter
Description
PCHConguration
PCHSATAConguration
Press[Enter]tocongureadvanceditems.

SATA Controller
– Enable/Disable SATA controller.
– Options available: Enable, Disable. Default setting is Enable.

CongureSATAas
– ConguresonchipSATAtype.
– AHCI Mode: When set to AHCI, the SATA controller enables its AHCI
functionality. Then the RAID function is disabled and cannot be
access the RAID setup utility at boot time.
– RAID Mode: When set to RAID, the SATA controller enables both its
RAID and AHCI functions. You will be allowed to access the RAID
setup utility at boot time.
– Options available: AHCI, RAID. Default setting is AHCI.

Alternate Device ID on RAID
(Note 1)
– Enable/Disable Alternate Device ID on RAID mode.
– Options available: Enable, Disable. Default setting is Disable
.

SATA Port 0/1/2/3/4/5/6/7
– ThecategoryidentiesSATAharddrivesthatareinstalledinthe
computer. System will automatically detect HDD type.
(Note 1) Only appears when HDD sets to RAID Mode.