Gigabyte MW50-SV0 - Page 13

- 13 -
Hardware Installation
Internal
Connectors
 1 x 24-pin ATX main power connector
 1 x 8-pin ATX 12V power connector
 13 x SATA3 6Gb/s connectors
 1 x mSATA connector/miniPCIe 5Gb/s connector (Auto-detect device)
 1 x PMBus header
 1 x CPU fan header
 4 x System fan headers
 1 x Front panel header
 1 x HDD Back plane borad header
 1 x USB 3.0 header
 1 x USB 2.0 header
 1 x USB 3.0 Type A connector
 1 x TPM module connector
 1 x Serial port connector
 1 x Front audio connector
 1 x Thunderbolt connector
 2 x SATA SPGIO headers
 1 x S/PDIF in header
 1 x S/PDIF out header
 1 x Software RAID key connector
 1 x LAN3 Active LED header
 1 x Chassis intrusion alert header
Rear Panel I/O  4 x USB 3.0 ports
 4 x USB 2.0 ports
 3 x RJ-45 ports
 1 x COM port
 1 x PS/2 connector
 5 x Audio connectors (Center/Subwoofer Speaker Out, Rear Speaker Out, Line
In/Mic In, Line Out, Headphone)
 1 x Optical SPDIF Out
I/O Controller  ITE
®
8732F chip
Hardware
Monitor
 System voltage detection
 CPU/System temperature detection
 CPU/System fan speed detection
 CPU/System fan speed control
* Whether the CPU/system fan speed control function is supported will depend on
the CPU/system cooler you install.
BIOS  1x128Mbitash
 AMI BIOS
Form Factor  ATX Form Factor; 12 inch x 9.6 inch
*GIGABYTEreservestherighttomakeanychangestotheproductspecicationsandproduct-relatedinformationwithout
prior notice.