Gigabyte MW50-SV0 - Page 24

Hardware Installation
- 24 -
• ARAID0orRAID1congurationrequiresatleasttwoharddrives.Ifmorethantwoharddrives
arecongured,thetotalnumberofharddrivesmustbeanevennumber.
• ARAID10congurationrequiresfourharddrives.
(Note) WhenaRAIDcongurationisbuiltacrosstheSATA6Gb/schannels,thesystemperformanceof
  theRAIDcongurationmayvarydependsonthedevicesareconnected.
1
7
DEBUG
PORT
G.QBOFM
PinNo. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
Normal Mode:
PinNo. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 P5V
SATA DOM Mode:
9) SATA0_1/SATA_2_3 (SATA 6Gb/s Connectors)
10) SSATA_0_1/SSATA_2_3 (SATA 6Gb/s Connectors)
11) SATA4 (SATA 6Gb/s Connector/Support SATA DOM Function)
12) GSATA0/GSATA1/GSATA2/GSATA3 (SATA 6Gb/s Connector)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and
1.5Gb/s standard. Each SATA connector supports a single SATA device.
Please see page 32 for SATA DOM jumper setting.
7
7
1
1
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
SATA_0_1SATA4
SSATA_0_1
SATA_2_3
SSATA_2_3
SATA_0_1
GSATA1
GSATA0
GSATA2
GSATA3
SSATA_0_1
SATA_2_3
SSATA_2_3
13/14) SATA_SGP1/SATA_SGP2 (SATA SGPIO Headers)
SGPIO stands for Serial General Purpose Input/Output which is a 4-signal (or 4-wire) bus used between
a Host Bus Adapter (HBA) and a backplane. Out of the 4 signals, 3 are driven by the HBA and 1 is driven
by the backplane. Typically, the HBA is a storage controller located inside a server, desktop, rack or
workstation computer that interfaces with Hard disk drives (HDDs) to store and retrieve data.
2
8
1
7
PinNo. Denition
1 DATAIN
2 No Pin
3 DATAOUT
4 GND
5 GND
6 LOAD
7 NC
8 CLOCK
SSATA_SGP1
SATA_SGP1