BIOS Setup - 50 -
Parameter
Description
USB hardware delays and time-outs
USB transfer time-out
Selects the time-out value for USB Control/Bulk/Interrupt transfers.
Options available: 1 sec, 5 sec, 10 sec, 20 sec.
Default setting is 20 sec.
Device reset time-out
Selects the time-out value during a USB mass storage device
reset.
Options available: 10 sec, 20 sec, 30 sec, 40 sec.
Default setting is 20 sec.
Device power-up delay
Maximum time the device will take before it properly reports itself
to the Host Controller. "Auto" uses default value: for a Root port it
is 100 ms, for a Hub port the delay is taken from Hub descriptor.
Options available: Auto, Manual. Default setting is Auto.
Mass Storage Devices Displays the mass storage devices available on the system.
To Next Page
Loading...
Need help?
General
