Gigabyte MZ71-CE0 - Page 65

BIOS Setup - 65 -
Parameter Description
Firmware Image Menu
Press[Enter]toviewrmwareimageinformation.
DeviceCongurationMenu
Press[Enter]tocongureadvanceditems.

Multi-Function Mode
– CongurestheNICHardwareMode.
– Options available: SF, NPAR 1.0. Default setting is SF.

Number of VFs Per PF
– ConguresthenumberofVirtualFunctionsPerPhysicalFunctionin
multiplesof8(1-128).ThiseldisonlyapplicablewhenSR-IOVis
enabled.
– Default setting is 8.

SR-IOV
– Enable/Disable Single Root I/O Virtualization.
– Options available: Enabled, Disabled. Default setting is Enabled.

Number of MSI-X Vectors per VF
– ConguresthenumberofMSI-XVectorsperVF(0-128).
– Default setting is 4.

Maximum Number of PF MSI-X Vectors
– ConguresthemaximumnumberofPFMSI-XVectors(0-512per
controller).
– Default setting is 74.

EnergyEfcientEthernet
– Enable/DisableEnergyEfcientEthernetoperation.
– Options available: Enabled, Disabled. Default setting is Enabled.

Operational Link Speed
– Conguresthelinkspeedsettingtobeusedasthedefaultlinkspeed
for the selected port.
– Options available: AutoNeg. Default setting is AutoNeg.

Firmware Link Speed
– Conguresthelinkspeedsettingtobeusedasthedefaultlinkspeed
for selected port in D3 state.
– Options available: AutoNeg. Default setting is AutoNeg.

Support RDMA
– Enable/Disable RDMA support for this port.
– Options available: Enabled, Disabled. Default setting is Disabled.

DCB Protocol
– Enable/Disable DCB protocol.
– Options available: Disabled, Enabled (IEEE only), CEE (only), Both
(IEEE preferred with fallback to CEE). Default setting is Disabled.

LLDP nearest bridge
– Enable/Disable LLDP nearest bridge state.
– Options available: Enabled, Disabled. Default setting is Enabled.

LLDP nearest non-TPMR bridge
– Enable/Disable LLDP nearest non-TPMR bridge state.
– Options available: Enabled, Disabled. Default setting is Enabled.