Gigabyte R262-ZA1 - Page 104

BIOS Setup - 104 -
5-3-3-1 DDR4 Common Options
Parameter Description
DDR4 Common Options
Enforce POR
Press [Enter] to congure the Plan of Record (POR) to enable / disable
restrictions for DDR4 frequency and voltage programming. Memory speeds
will be capped at AMD guidelines.

Decline

Accept
– Overclock
»
Enable/Disable Memory Overclock Settings
»
Options available: Auto, Enabled. Default setting is Auto.
Note: To enable 2 DIMMs per Channel at 3200MHz function, select
[Accept] at warning message, change Overclock from [Auto] to
[Enabled], and then set memory speed to 3200MHz.
DRAM Controller Conguration Press [Enter] to congure DRAM Controller Conguration.
CAD Bus Conguration Press [Enter] to congure CAD Bus Conguration.
Data Bus Conguration Press [Enter] to congure Data Bus Conguration.
Common RAS Press [Enter] to congure Common RAS.
Security Press [Enter] to congure Security.
Phy Conguration Press [Enter] to congure Phy Conguration.