Gigabyte R262-ZA1 - Removing the Heat Sink

System Hardware Installation - 32 -
3-3 Removing the Heat Sink
R262-ZA1
Follow these instructions to remove/install the fan duct:
1. Loosen the captive screws securing the heatsink in place in reverse order (4
g
3
g
2
g
1).
2. Lift and remove the heat sink from the system.
3. To reinstall the heat sink reverse steps 1-2 while ensuring that you tighten the captive screws in
sequential order (1
g
2
g
3
g
4) as seen in the image below.
3
3
1
1
2
2
44
When installing the heatsink to CPU, use PHILLIPS #2-Lobe driver to tighten 4 captive nuts in
sequence as 1-4. The screw tightening torque: 10 ± 0.5 kgf-cm (8.7 ± 0.4 lbf-in).