Gigabyte S451-3R1 - Removing and Installing the Power Supply

- 37 - System Hardware Installation
3-8 Removing and Installing the Power Supply
Follow these instructions to replace the power supply:
1. Flip up the power supply handle.
2. Press the retaining clip on the left side of the power supply unit along the direction of the arrow.
3. Pull the power supply handle at the same time and pull out the power supply unit.
4. Insert the replacement power supply unit rmly into the chassis. Connect the AC power cord to the
replacement power supply.
5. Repeat steps 1-3 for replacement of the second power supply.
2
1
3
Before you remove or install the power supply unit:
• Make sure the system is not turned on or connected to AC power.