Gigabyte S451-3R1 - Page 69

- 69 - BIOS Setup
Port Level Conguration
Press [Enter] to congure advanced items.

Link Speed
– Allows for automatic link speed adjustment.
– Options available: Auto Negotiated/1 Gbps/10 Gbps/SmartAN.
Default setting is Auto Negotiated.

Boot Mode
– Select the preferred boot protocol or disable.
– Options available: PXE/Disabled. Default setting is PXE.

DCBX Protocol
– Enables/Disables DCB Protocol.
– Options available: Disabled/IEEE/CEE/Dynamic. Default setting is
Dynamic.

RoCE Priority
– Enter desired RoCE Priority within a range of 0 to 7

PXE VLAN Mode
– Congure virtual LAN mode.
– Options available: Enabled/Disabled. Default setting is: Disabled.

Link Up Delay
– Maximum amount of time in seconds UEFI or Legacy driver will
wait for Management FW to bring-up the link.

RDMA Protocol Support
– Specifiy which Remote Direct Memory Access Protocol is to be
used.
– Options available: None/RoCE/IWARP. Default setting is: RoCE
Partition Mode
Select the desired port partitioning mode.
Options available: Default/NPAR. Default setting is: Default
Device Name
Displays the technical specications for the Network Interface Controller.
Chip Type
Displays the technical specications for the Network Interface Controller.
PCI Device ID
Displays the technical specications for the Network Interface Controller.
PCI Address
Displays the technical specications for the Network Interface Controller.
Link Status
Displays the technical specications for the Network Interface Controller.
Link Speed
Displays the technical specications for the Network Interface Controller.
Permanent MAC Address
Displays the technical specications for the Network Interface Controller.
Virtual MAC Address
Displays the technical specications for the Network Interface Controller.
SL_CN1 (top)