Gigaset E260 - Resetting the Base to the Default Settings

43
Setting the base
Gigaset E260 / Belgien en / A31008-M2301-M201-1-3F19 / T-NetBox-registration.fm / 16.01.2017
Version 5, 03.04.2011
Resetting the system PIN
If you have forgotten your system
PIN, you can reset the PIN to the
original code 0000 using the but-
ton on the base. This will also reset
other settings; see the section enti-
tled "Resetting the base to the
default settings".
Resetting the base to the
default settings
When restoring default settings:
u Individual settings are reset
u All lists are deleted
u Eco Mode and Eco Mode+ are
deactivated.
The date and time are retained.
Resetting the base via the menu
When resetting via the menu
u Handsets are still registered
u The system PIN is not reset.
§Menu§ ¤ q Settings ¤ §OK§
¤ q Base ¤ §OK§
¤ q Base Reset ¤ §OK§
Resetting the base using the
button on the base
When resetting the base using the
button on the base
u All handsets are de-registered
and
u The system PIN is reset to the orig-
inal code 0000
Proceed as follows:
¤ Remove the mains cable from the
base.
¤ Hold down the registration/pag-
ing key on the base (¢ page 1)
while reconnecting the power
cable to the base. Hold the key
down for at least 5 seconds.
Please note
All handsets are de-registered
and must be re-registered. All set-
tings are reset to the default set-
tings.