POP UP
PRIVACY POD
Owner’s Manual
Model # ST002BG
36" x 36" x 72” (H)
ASSEMBLY INSTRUCTIONS DISASSEMBLY INSTRUCTIONS
IMPORTANT
We strongly suggest setting up your new
tent before going camping to insure that
all parts are present and to familiarize
yourself with the tents assembly. This
will have a great effect on how well you
enjoy your camping trip.
STEP 1:
Confirm product contents by emptying contents of bag(s)
and confirming all parts are included and undamaged.
STEP 2:
Select a smooth level site prior to opening the structure.
STEP 3:
Pull frame apart to pop open structure.
CAUTION: Structure has inner steel wire which may spring open
suddenly while attempting to open.
TIP: Frame may need minor adjustment when tent is set up. Gently bend
frame into shape if sagging appears.
STEP 4:
Stake down structure on bottom four corners.
It is strongly recommended to attach supplied guylines at the corners
near the top of structure and stake down to the ground.
STEP 1:
Pick up the structure and lay it on its side.
STEP 2:
Grasp the top of frame and push one of the corners INTO the structure
towards the OPPOSITE corner.
STEP 3:
The structure will now fold flat.
STEP 4:
Grasp 2 DIAGONALLY OPPOSITE corners and bring them together in
one hand. (You now have a loop above and below your hande)
STEP 5:
Kneel down and place the bottom loop on the ground.
STEP 6:
Grasp the outer edge of the top loop furthest away from you and fold
inward toward the lower loop and lay flat on the ground. (You now
have 2 loops on top of a larger one)
STEP 7:
Slide one of the smaller loops over the one next to it and grasp the
outside edges of the entire folded playhouse.
STEP 8:
Slowly move your hands around the outside edges to make all of the
loops the same size.
STEP 9:
Place folded structure into carry case.
Pop-Up
Privacy Pod
To Next Page
Need help?
General
