3
Safety
Important Safety Instructions
The buyer is responsible for ensuring that users are proper-
ly trained, that they are aware of all the information and in-
structions in this document, and that they are aware of the
potential risks of operating the machine� The manufacturer
will not be held responsible for any damage to people and/
or property caused by non-compliance with any instructions
in this manual�
Read all safety warning and instruc-
tions. Failure to follow the warnings and instructions
may result in electric shock, re, and/or serious inju-
ry. Keep these instructions for later use.
The purpose of safety symbols is to attract your attention
to possible dangers� The safety symbols, and their expla-
nations, deserve your careful attention and understanding�
The safety warnings DO NOT by themselves eliminate any
danger� The instructions or warnings they give are not sub-
stitutes for proper accident prevention measures�
Signals an EXTREME hazard. Failure
to obey a safety DANGER symbol WILL result in seri-
ous injury or death to yourself or to others.
Signals a SERIOUS hazard. Failure to
obey a safety WARNING symbol CAN result in seri-
ous injury to yourself or to others.
Signals a MODERATE hazard. Failure
to obey a safety CAUTION symbol MAY result in prop-
erty damage or injury to yourself or to others.
NOTE: Advises you of information or instructions vital to
the operation or maintenance of the equipment�
General Safety Warnings
Do not perform tasks on the machine
other than those for which it was designed. Only use
the machine in the manner in which it was intended,
as described in this instruction manual.
• Keep work area clean and well lit�
• Keep children and bystanders away while operating
the machine�
Testing Screen Safety Warnings
The Testing Screen is NOT explo-
sion-proof or approved for operation in hazardous
locations. Only operate the testing screen in a prop-
erly ventilated area. DO NOT operate in explosive or
hazardous atmospheres, such as in the presence of
ammable liquids, gases or dust.
• The Testing Screen is NOT counterbalanced� It must be
adequately mounted to a substantial, rigid foundation to
prevent excessive vibration. A poured concrete oor
is recommended�
• Level the Testing Screen before operation�
During Operation
Dress properly� DO NOT wear loose clothing or jewelry�
Keep your hair, clothing and gloves away from moving
parts� Secure hair above shoulder level� Loose clothes,
jewelry or long hair can be caught in moving parts�
• DO NOT operate the machine without all guards and
covers in place�
• Keep all body parts away from moving parts of the
machine while it is in operation�
• Wear approved NIOSH/ MSHA respirator as required by
the sample to prevent inhaling any dust which may be
considered hazardous�
• Wear safety glasses or goggles that meet current
ANSI / ISEA Z87�1 standards and are marked as such�
• Wear ear/hearing protection when operating
this machine�
• If the machine starts to vibrate abnormally, stop the
machine immediately� Inspect the machine for the cause
of the vibration�
To Next Page
Loading...