4
Electrical Safety
Electric Shock Hazard. Touching some
of the internal components can cause serious per-
sonal injury or death. Disconnect the power supply
before removing covers or performing maintenance
on the machine.
Electric Shock Hazard. Improper use
of the grounding can result in electric shock. Do not
plug the machine into an outlet until it is properly
installed and grounded.
The supply voltage must correspond
to that stated on the identication plate and in the
technical specications. NEVER use any other type
of power supply.
Remove plug from the mains immedi-
ately if the cable is damaged or cut.
• This machine must be grounded� In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the elec-
tric current� This machine is equipped with a cord having
a grounding wire with a grounding plug� The plug must
be plugged into an appropriate outlet that is properly in-
stalled and grounded in accordance with all local codes
and ordinances�
• Do not modify the plug provided with the machine: if it
will not t the outlet, have a proper outlet installed by a
qualied electrician.
• Consult a qualied electrician or service technician if
the grounding instructions are not completely under-
stood, or if doubt exists as to whether the machine is
properly grounded�
• If it is necessary to use an extension cord, use only a
3-wire extension cord that has a 3-blade grounded plug,
and 3-slot receptacle that will accept the plug on the
machine� The marked rating of the extension cord shall
be equal to or greater than the electrical rating of the
machine�
• Make sure that the power cord does not come into con-
tact with hot objects, wet or oiled surfaces, and/or sharp
edges�
• The power cord should be checked regularly and before
each use to check for signs of damage or wear� If the
power cord is worn or damaged, replace the cord�
• Do not use the power cord to remove the plug from the
socket or move the machine�
SAVE THESE INSTRUCTIONS
To Next Page
Loading...