20
Select Measurement Unit
With batteries correctly installed, press “UNIT” button in the back of the scale to select measurement
unit. The default measurement unit is “kg”. You may press “UNIT” button to choose between kilogram,
pound and stone.
CAUTION
Please put the scale on at hard ground when nishing the unit selection. Wait for a few seconds,
then you may start measuring according to the measuring procedure below. If there is not any oper-
ation in weighing mode, the scale will turn off after a few seconds.
Initialising Your Scale
1. Press the platform centre and remove your foot.
2. “0.0” will be displayed.
3. The scale will switch off and is now ready for use.
This initialisation process must be repeated if the scale is moved. At all other times step straight on the
scale.
ENGLISH
To Next Page
Loading...
