To Next Page

To Previous Page

Weight Only Operation

The Body Fat Analyzer will operate as a conventional weight - reading scale. No special programming

steps are required.

Once the scale is initialized, as previously described, you may simply step on the scale to measure your

current weight. For only weight reading.

1. Position the scale on a at, hard surface.

Carpeted or uneven oors may affect accu-

racy.

2. Step onto the scale platform and remain still

while the scale computes your weight.

3. The scale will display your weight value.

4. The scale will turn off after a few seconds

Set Up Your Prole

The body fat analyzer GBF-835 supports multiple users (Up to Eight). You may follow below instructions

to assign User ID and set up your own prole, including Gender, Stature, and Age.

1. Assigning User ID

• With batteries correctly installed, press “SET” key to enter setting when the scale

is off.

• The system will request User ID selection rst. As pictured below, “P1” blinks.

The operator may press the function key  or  to select User ID among P1 to

P8.

• Press “SET” key to conrm User ID.

2. Setting Gender

• After conrming User ID, the system will divert to Gender setting.

• As pictured below, the portrait blinks. The operator may press the function key  or  to select

Gender( Male/Female/Male Athlete/ Female Athlete).

• Press “SET” key to conrm Gender.

Athlete Mode:

An athlete is considered as a person who does 10 hours or more per week of aer-

obic activity and has a resting heart rate of 60 beats per minute. These individuals

should select Athlete Mode for the most accurate measurement results. The body

fat analyzer are not calibrated for professional athletes or body builders.

3. Setting Stature

• After conrming Gender, the system will divert to Stature setting automatically.

• As pictured below, the digits “ 165 ”blinks. The operator may press the function

key  or  to increase or decrease the numeral.

• You may press and hold the function key  or  for fast changing the numer-

al.

• Press “SET” key to conrm.

ENGLISH

Gima LIBRA User Manual

Other manuals for Gima LIBRA