16
WARNING: When installing the reserve make
sure the reserve handle is up and the reserve
lines are facing down.
Rescue installation guide
It is very important to properly install the rescue parachute. If the parachute is not folded correctly or
the lines are not placed properly then a serious if not fatal accident could result. If you have any doubts
speak with your instructor or GIN dealer.
Main rescue installation guide
Begin by first connecting the Y bridle and the rescue handle to the rescue parachute . Install the rescue
into the harness with the handle connection FACING UP and the extra para line neatly folded on the bottom
of the container. Be sure that the inner bag is installed so the rescue handle loop is facing the opening of
the rescue container.
Close the rescue container in the following order.
1) Insert reserve with rescue bridle on bottom and handle attachment facing out
2) Connect the LEFT zipper and bring both zippers to the center of the rescue container
3) Pull the anchor loops through the outer container cover grommets
4) Pass the rescue handle wire through the anchor points and hide the ends in the wire covers
5) Close both zippers.
IMPORTANT: Make sure both zippers are fully closed! The LEFT zipper must run all the way off the
zipper track or it will interfeer with rescue deployment.
Rescue container volume: 3000-7000cm
3
*Follow the instructions on the next page.
To Next Page
Loading...
