9
CAUTION: Make sure that the speed system
is not too short. The front risers of your
paraglider must not be pulled down in normal
(unaccelerated) flight.
Speed line should go between airbag and
harness, do not run the speed line on the
outside of the airbag!
Before you fly
Make sure your dealer has checked the harness for completeness and basic settings. Your harness must
be assembled by a suitably qualified paragliding professional, for example, your instructor.
Gin Gliders recommends that assembly be carried out in the following order. If you are in any doubt
whatsoever about this procedure, please seek professional advice from your instructor, GIN dealer or
importer.
Setting up
Speed system assembly
The Yeti Convertible 2 is fitted with a fully functional, easy to use and lightweight speed bar. Careful
attention has gone into the precise position for maximum comfort and usability. To assemble the speed
system, first pass the line through the ceramic ring (1). Next, pass the line through the metal ring at the
bottom edge of the seat (2). Connect the line to the speedbar using a secure knot.
The black plastic stopper on the speed system should be placed above the ceramic ring during assembly
This can be used to hold the speed bar close to the harness during ground handling and take off. Once in
the air simply push the speed bar and the stopper will slide out of the way.
To connect the speedbar to your glider riser use a simple loop knot (3).
2
1
1
2
3
To Next Page
Loading...
