19
Connecting a front reserve
The reserve risers can be connected to:
1) Main carabiner (as shown in the photo)
- Be sure that the carabiner gate is facing the pilot to allow
the reserve to freely slide up the carabiner in the event of a
rescue deployment.
2) Shoulder attachment points
- To connect to the shoulder attachment points we recommend
using the Light Yeti Rescue “Y” Bridle 80cm
- Pass the rescue bridle along the RIGHT side of the harness
and through the rescue bridle tunnel.
CAUTION: Make sure that carabiner gate faces
the rear of the harness to allow the reserve
risers to move unimpeded.
To Next Page
Loading...
