SECTION 3: ASSEMBLY
Only minimal assembly is required for your new e-bike. You will be required to do the following:
Front wheel installation:
First, make sure all hardware is exists. You should have front axle + spacer + 2 springs (some models will
have only 1 spring) + nut.
Attach the wheel based of illustration below – Make sure that the rotor sitting properly inside brake
caliper.
Unfolding the Frame
The frame of your bike folds in the middle. The quick-release latch is released and lifted up to allow the
locking pin to release and unfold the bike.
Insert Upper Handlebar Stem
Quick-release latch locked
Quick-release latch unlocked
and locking pin released
To Next Page
Loading...
