Connecting the battery
Your battery ships with the battery disconnected. First ensure your scooter ignition is in
the off position. (See pg #10) Open the under seat compartment then lift and remove
the gray plastic under-seat tray. Below the tray sits your scooter’s electronics including
the battery, controller and breaker.
Locate the battery cable which is a brown and red wired cable. For shipping the contact
of this cable will be covered in electrical tape. Remove the tape and attach the lead to
the empty red terminal on the battery. Don’t forget to place the attached cap over the
completed connection.
Your Royale may also ship with the connection between the controller and breaker
disconnected. Look for a single unconnected red wire leading from the control unit,
insert the lead on that wire into the breaker and tighten with the screw on the breaker
above the connection. If the wire was preconnected, ensure the connection is tight. Flip
the breaker to the on position (See pg #10) and the scooter will be ready for its first
charge. (See pg #14)
7
To Next Page
Loading...
