HomeServer 3 - Commissioning
11
10.2006/V 1.0
2.3.1 Connecting to the power supply
The HomeServer needs to be connected via the external power supply unit with the
power supply (230 V~). Connect the HomeServer to the power supply as follows:
1. Connect the mains cable for the power unit with the external power supply unit.
2. Connect the power supply unit with the interface to the power supply at the Home-
Server.
3. Connect the power supply unit to the power supply.
Attention: HomeServer starts immidiately when connected to the power
supply!
The HomeServer starts immidiately after the device has been connected with the power
supply. It can then be switched off after approx. 10 seconds by the On/Off button on the
front side of the device.
i
Note: Green LED at the power supply unit.
There is a green LED on the top side of the power supply unit. If the LED lights perma-
nently then the power supply unit is ready for operation.
Attention: Carry out lightning protection!
To avoid damages to the device, we strongly recommend that you secure the HomeSer-
ver against over-voltages at the ISDN connection, the network connection, in the power
line as well as in the EIB power input, by using appropriate protective equipment.
To Next Page
