Need help?Do you have a question about the Gira One and is the answer not in the manual?
Overview of device components from the front, including rockers and status LEDs.
Overview of device components from the rear, showing terminals and fixing clips.
Details the various functions the pushbutton sensor can perform, such as switching and dimming.
Covers features related to temperature sensing and calibration for the device.
Explains the configuration options for the status LEDs, including brightness and color.
Details on mounting and connecting the device, including safety warnings and component identification.
Instructions on how to commission the device using the Gira Project Assistant (GPA).
Explains how to activate and deactivate the safe-state mode for diagnosis and programming.
Procedure to perform a master reset to restore basic device settings.
Provides specific measurements and dimensions for device installation.
Allows setting the brightness level for the status LEDs.
Enables selection of the color for the status LEDs.
Defines the behavior of the status LEDs, such as on/off or status indication.
For adjusting temperature readings from the integrated or remote sensor.
Overview of device components from the front, including rockers and status LEDs.
Overview of device components from the rear, showing terminals and fixing clips.
Details the various functions the pushbutton sensor can perform, such as switching and dimming.
Covers features related to temperature sensing and calibration for the device.
Explains the configuration options for the status LEDs, including brightness and color.
Details on mounting and connecting the device, including safety warnings and component identification.
Instructions on how to commission the device using the Gira Project Assistant (GPA).
Explains how to activate and deactivate the safe-state mode for diagnosis and programming.
Procedure to perform a master reset to restore basic device settings.
Provides specific measurements and dimensions for device installation.
Allows setting the brightness level for the status LEDs.
Enables selection of the color for the status LEDs.
Defines the behavior of the status LEDs, such as on/off or status indication.
For adjusting temperature readings from the integrated or remote sensor.
To Next Page
General