9 Parameter list
Parameters that can be set via the GPA:
Status LED brightness Off
Heavily dimmed
Dimmed
Normal
Bright
Very bright
The brightness of the status LEDs can be defined here.
In the case of the push-button sensor 2-gang or 3-gang, this setting applies to all
LEDs.
Colour Red, green, blue, yellow, cyan, orange,
violet, white
The colour of the status LEDs can be defined here.
In the case of the push-button sensor 2-gang or 3-gang, the colour of the status
LEDs can be defined separately for each rocker.
Function always OFF
always ON
Button-actuation display
Status indication
The function of the status LEDs can be defined here.
In the case of the push-button sensor 2-gang or 3-gang, the function of the status
LEDs can be defined separately for each rocker.
The settings have the following functions:
– always OFF
The status LED is always off
– always ON
The status LED is always on.
– Button-actuation display
The status LED lights up when the rocker is actuated.
– Status indication
The status LED indicates the state of the function triggered by the rocker.
If the feedback for several switch loads is displayed, the status LED is then
switch on (if at least 1 load from the group is switched on).
Temperature calibration - 12.8 ... 12.7 K
The value for the temperature calibration can be entered here if the temperature
measured by the temperature sensor in the push-button sensor or by the connected
remote sensor differs from the actual room temperature.
17 / 19
32406222 10871142 19.12.2023
Pushbutton sensor 4 Komfort System 55
To Next Page
Loading...
