7
Setting up retractable hose reel
Wooden post
Tips: We don’t recommend wooden posts that can only carry weight up to 20kg, to install the bracket.
PRODUCT TESTING
Use the installation template(page 15) to mark the location of the 4 holes.
Use a 5/16" drill bit to drill 1-31/32''/4.98cm deep holes.
Hold the bracket in place.
Put the screws in and then tighten the screws.
Lift the reel and slide it into the bracket holes.
Screw the small screw to the bottom of the bracket and then tighten.
Connect the leader hose connector to the faucet.
Connect the nozzle to the hose.
Tighten the nozzle and leader hose connector.
Check if the water hose is leaking:
- Leaking near the faucet
- Leaking near the hose reel
Check whether the nozzle is leaking.
Check whether the hose retracts normally:
- Can't retract automatically
- Unable to pause
Check whether there is an o-ring in the hose connection.
If you have any of the above issues, please contact our customer service, by sending an
email to contact@giraffetools.com and provide your corresponding video and order
number.
1.
2.
3.
4.
1.
2.
3.
4.
5.
1.
2.
3.
4.
Your hose reel is now installed and ready to use!
To Next Page
Loading...
