6
5. Close the lid, rotate the crank handle clockwise to wind the hose
into the cabinet.
4. Uncoil your garden hose (not included), put its female connector
through the regulator and connect it to the water inlet.
Tips: To prevent leakage, it is recommended to use a wrench. Make sure the
rubber washer is placed in the connector.
Install the crank handle: Align the screw holes on the crank
handle and the side cover, insert the screw and
tighten the
screw with a screwdriver.
3. Align the regulator of the hose guide system to the water inlet side
of the metal body, if the regulator is not in the right position,
lift its latch to unlock the regulator and adjust its position, then
re-lock the regulator through the latch.
Notice: Make sure the guide system regulator is placed at the screw rod with
thread, otherwise the guide system may be out of operation.
2.
Notice: The nut has been fixed in advance in the corresponding position
on the side cover. If you do not find the nut in the corresponding position,
please look through the packaging or contact Giraffe Tools customer service
team.
To Next Page
Loading...