Glacier bay FP4A4080SS User Manual

Connecting water supply lines
Checking for leaks
Attaching the weight
Connect the water supply lines (F) and tighten
the water supply nuts (1).
Remove the spray head (B) from the hose (K). Hold
the hose tightly to prevent it from retracting.
Turn on the water supply and check all of the
water connections for leaks.
If you discover any leaks, check the
connections to ensure they are installed properly.
Run the water for approximately 1 minute to
ush the lines.
Re-attach the spray head (B).
Locate the lowest point on the hose (L) and
attach the rubber weight (K) to the hose (L).
Use a Phillips screwdriver to secure.
Installation (continued)
10
12
11
F
1
1
1
K
L
B
8

Glacier bay FP4A4080SS Specifications

General

Brand	Glacier bay
Model	FP4A4080SS
Category	Kitchen & Bath Fixtures
Language	English