Glacier bay HD873X-5D01

Questions and Answers

M
Marilyn PetersonAug 6, 2025
What to do if there is leaking or dripping from the spout of my Glacier Bay Bathroom Fixtures when the handle is closed?
- J
  jackielevyAug 6, 2025
  If you notice leaking or dripping from the spout when the handle is closed, it could be due to a few reasons. The cartridge might not be properly installed, so try reinstalling it. Also, check to ensure the sealed washer on the cartridge is in place; if it's missing, replace the cartridge. Another possibility is that the bonnet nut isn't tightened enough. Use a wrench to retighten the bonnet nut sufficiently.
A
Andrew WilliamsAug 12, 2025
Why is there no flow or low water flow in my Glacier Bay Bathroom Fixtures?
- T
  tporterAug 12, 2025
  A lack of water flow or low water flow could be caused by several factors. Check if one or both water supplies are not turned on and ensure both water supply valves are in the 'on' position. Also, the stop valves might be turned off or not fully turned on; make sure to fully turn them on. Finally, the screen filter in the spray head could be blocked. To resolve this, turn off the water supply at the angle valve and unscrew the spray head from the spray hose, then clean the screen filter under running water.
S
Stephanie LandryAug 18, 2025
What to do if water comes out of the tub spout and showerhead at the same time in my Glacier Bay Bathroom Fixtures?
- S
  Scott GarciaAug 18, 2025
  If water is coming out of both the tub spout and showerhead simultaneously, it could be due to several reasons: * The pipe used between the valve and the tub spout is not 1/2 in. IPS, or the COPPER pipe is incorrect. Change the pipe to IPS or COPPER. * The distance between the valve and the showerhead is less than 48 in.. The distance from the showerhead and valve moved to at least 48 in.. * There is a restriction between the valve and the tub spout. Remove the tub spout, flush out any debris, and replace any undersized lines or fittings. * The valve is installed upside down. Remove the valve and reinstall it with the correct orientation.
T
Timothy YoungAug 25, 2025
Why is the handle hard to turn on my Glacier Bay Bathroom Fixtures?
- J
  joel80Aug 25, 2025
  If the handle is hard to turn, the bonnet nut might be too tight. Try loosening the bonnet nut and reinstalling it, being careful not to overtighten it.
S
Stephanie ShermanAug 29, 2025
Why is there no hot water in my Glacier Bay Bathroom Fixtures?
- M
  Marie JonesAug 29, 2025
  The absence of hot water could be due to a couple of reasons. First, the lines might be reversed, or the cartridge could be installed upside down. In this case, rotate the cartridge 180°. Alternatively, the balance valve in the cartridge might be clogged with debris. If so, clean the bottom of the cartridge.