To Next PageTo Next PageHow to fix leaks from the handle of Glacier bay HD67499W-6404 Bathroom Fixtures?
Leaks from the handle of your Glacier Bay Bathroom Fixtures are often caused by a loose bonnet nut or a dirty/damaged washer. Try tightening the bonnet nut first. If the leak persists, clean or replace the washer.
What to do if the water will not shut off completely in Glacier bay HD67499W-6404 Bathroom Fixtures?
If the water from your Glacier Bay Bathroom Fixtures faucet won't shut off completely, it might be due to a dirty or broken rubber seat and spring. To address this, remove the cartridge to inspect the rubber seat and spring, then clean or replace them as needed.
Why does the aerator have an irregular or reduced water flow in Glacier bay HD67499W-6404 Bathroom Fixtures?
An irregular or reduced water flow from the aerator in your Glacier Bay Bathroom Fixtures usually indicates that the aerator is either dirty or mis-fitted. Start by removing the aerator to check for any debris. Also, make sure the rubber washer is correctly installed.
What to do if there is leaking from the sink drain at the base of the Glacier bay HD67499W-6404 sink?
Leaking from the sink drain at the base of your Glacier Bay Bathroom Fixtures sink could be due to a rough or irregular sink surface. Try applying additional silicone sealant to the beveled side of the drain flange. Then, retighten the drain and test for any further leaks.
General| Finish Family | Chrome |
|---|---|
| Handle Style | Lever |
| Material | Metal |
| Aerator Included | Yes |
| ADA Compliant | Yes |
| Showerhead face diameter (in.) | 4.72 |
| Flow Rate | 1.8 gpm |
Ensure all parts are present and compare with the Package Contents list before installation. Contact Customer Service for missing or damaged parts.
Lists necessary tools such as adjustable wrench, safety goggles, silicone sealant, supply lines, pliers, and hacksaw.
Details all parts included in the faucet assembly and drain assembly, with quantities for each.
Instructions for shutting off water, cleaning the surface, placing the gasket, and securing the faucet to the sink.
Guide on removing the pop-up stopper and drain flange from the drain body before assembly.
Steps to apply sealant, place the drain flange, screw the drain body, and tighten the rubber washer and lock nut.
Instructions for inserting the stopper and horizontal rod into the drain body and stopper until it clicks.
Guide on sliding the lift rod down into the lift rod strap through the faucet until it clicks.
Steps to press the horizontal rod, adjust and insert the lift rod strap, and secure the clip.
Optional step to cut the lift rod strap shorter if it interferes with installation.
Verify that the stopper opens and closes correctly by operating the lift rod.
Instructions for using 1/2 in. I.P.S. connections or supply line coupling nuts and tightening them.
Procedure to remove the aerator, flush water lines, check for leaks, and reinstall the aerator.
