Glacier bay KAGAN 21-K153KSS-GB User Manual (English)

Questions and Answers:

M
Michelle VasquezAug 10, 2025
What to do if there is no water pressure in Glacier Bay Plumbing Product?
- E
  Evan BarkerAug 10, 2025
  If you're experiencing no or low water pressure from your Glacier Bay Plumbing Product after using it for a while, there could be a blockage in the hose or debris trapped in the supply line connectors. To resolve this, first, try removing the spray head and flushing the hose assembly. If the water flow remains slow, the issue might be with debris inside the supply line connectors. In that case, shut off the water supply, disconnect the lines, clean out any debris, and then reattach and tighten them. Be careful not to overtighten. Finally, turn the water supply back on.
M
Matthew BenjaminAug 15, 2025
Why is my Glacier Bay Plumbing Product faucet leaking around the aerator?
- S
  suttonjacobAug 15, 2025
  If your Glacier Bay Plumbing Product faucet leaks around the aerator, it's likely due to the aerator not being fitted correctly, being dirty, or having small parts improperly installed inside. To fix this, remove the aerator from the spout on the faucet body. Check the black rubber gasket inside the aerator to ensure it's flat. Then, reinstall the aerator onto the spout.
C
Cheryl GreenAug 22, 2025
How to fix an improper water pattern in Glacier Bay Plumbing Product?
- M
  Michael ThompsonAug 22, 2025
  If your Glacier Bay Plumbing Product faucet has an improper water pattern, it is probably because the aerator is dirty or the small parts inside the aerator are not installed correctly. Remove the aerator from the spout on the faucet body and gently flush the small parts inside to remove any debris. Then, reinstall the aerator on the spout.
E
Emily WellsAug 27, 2025
Why won't the mounting nut tighten on my Glacier Bay Plumbing Product?
- V
  Vanessa RobertsonAug 27, 2025
  If the mounting nut won't tighten on the faucet shank of your Glacier Bay Plumbing Product, it's probably because the quick-install mounting nut wasn't pushed upward over the faucet shank before rotating. Push the quick-install mounting nut upwards over the faucet shank until it is pressed firmly against the underside of the sink and turn to tighten.
E
Eric GomezSep 3, 2025
How to fix Glacier Bay Plumbing Product that won't completely shut off?
- K
  Kelly BarberSep 3, 2025
  If the water doesn't completely shut off with your Glacier Bay Plumbing Product, it's likely because the ceramic cartridge discs are worn or have debris trapped inside. To resolve this, shut off the water supply, move the handle to the OFF position, unscrew the handle screw and remove the handle. Then, remove the bonnet and lift out the ceramic cartridge. Position the new ceramic cartridge into the faucet body, tightly screw the bonnet back in, and reinstall the handle.