What to do if there is no flow or low water flow from my Glacier Bay Plumbing Product?
If you're experiencing no water flow or low water flow with your Glacier Bay Plumbing Product, it might be due to one or both water supplies not being turned on. Make sure that both water supply valves are turned counterclockwise to the on position.
Why is my Glacier Bay Plumbing Product leaking or dripping from the spout when the handle is closed?
If your Glacier Bay Plumbing Product is leaking or dripping from the spout when the handle is closed, it could be that the grommets are not sealing properly. The suggested solution is to replace the cartridge.
How to fix reversed hot and cold water on a Glacier bay HD873X-6201 Plumbing Product?
If the hot and cold are reversed on your Glacier Bay Plumbing Product, it's possible that the lines are reversed or the cartridge is installed upside down. Rotate the cartridge stem 180° so that the notch is facing down towards the drain.
Why is the handle on my Glacier Bay Plumbing Product hard to turn?
If the handle on your Glacier Bay Plumbing Product is hard to turn, the bonnet nut might be too tight. Loosen the bonnet nut and reinstall it, being careful not to overtighten it.
Why the handle of my Glacier bay HD873X-6201 Plumbing Product cannot be installed or rubs against the escutcheon?
If the handle cannot be installed or the handle rubs against the escutcheon on your Glacier Bay Plumbing Product, the valve might be installed too far back from the finished wall. Reinstall the valve.
What to do if water comes out of the tub spout and showerhead at the same time in my Glacier bay HD873X-6201?
If water comes out of the tub spout and showerhead at the same time with your Glacier Bay Plumbing Product, it could be due to several reasons: * The pipe used between the valve and the tub spout is not 1/2 in. IPS, or the COPPER pipe is incorrect - change the pipe to IPS or COPPER. * The distance between the valve and the showerhead is less than 48 in. - move the distance from the showerhead and valve to at least 48 in. * There is a restriction between the valve and the tub spout - remove the tub spout and flush out debris and/or replace the undersized line or fittings. * The valve is installed upside down - remove the valve and reinstall it using the correct orientation. Also, if the pattern of the water flow switches to the shower from the tub spout, and the leak from the tub ...
Guidance on preparing for the installation process.
List of necessary tools and hardware for installation.
Steps to prepare the site and shut off water before installation.
Procedure for installing the valve body and removing the plaster guard.
Instructions for connecting hot/cold supply lines and outlet pipes.
Guidance for installing the valve body with reversed supply connections.
Flushing the system and checking for any leaks after installation.
Instructions for installing the plaster guard onto the valve body.
Procedure for installing the shower arm and shower flange.
Instructions for threading and tightening the tub spout.
Steps to remove the plastic cap from the valve body.
How to adjust the temperature limiter for desired water output.
Removing the red limit stop ring from the cartridge assembly.
Adjusting the red limit stop ring for colder or hotter water.
Reinstalling the inverter and sleeve onto the valve body.
Installing the escutcheon and attaching the handle.
Testing the faucet for leaks after installation is complete.
Procedure for attaching the shower head to the shower arm.
General| Brand | Glacier Bay |
|---|---|
| Flow Rate (gallons per minute) | 1.2 |
| Handle Style | Lever |
| Material | Metal |
| Warranty | Limited Lifetime |
| Product Type | Faucet |
| Spout Reach | 4.72 in |
| Flow Rate | 1.2 GPM |
To Next Page